How can I verify if my submersible water pump is running?

Since the submersible pump is installed down the well, it may not be possible to hear when the pump is turning on or off, therefore rapid cycling can be overlooked. The pressure gauge provides a means to monitor the pumps operation and run times (minutes the pump is on between pump cut-in (ON) and cut-out (OFF) i.e. 30-50 PSI).

Solution: The installation of a FSG-PL pilot light is a cost effective and simple solution. This pump light can be used with two or three wire motors in either 115 volt or 230-volt applications. It is easy to install at the pressure switch, where it is used to indicate that the pump is running or at the control box, where it is used to indicate that current is available to the submersible pump.

How can I tell if my pressure tank is waterlogged?

https://support.boshart.com/how-can-i-tell-if-my-pressure-tank-is-waterlogged